New Delhi, India: Air pollution levels in Delhi reached extremely dangerous levels on Diwali night. However, significant differences were observed in Air Quality Index (AQI) readings across various mobile applications and government monitoring stations. For the same location, India’s official AQI scale showed 387, the US scale indicated 1,469, while the UK scale recorded the maximum score of 10.
This raises an important question: If the air is the same, why do pollution figures differ so significantly across countries?
On Diwali night, at around 10 PM, the PM2.5 concentration in Delhi’s Nehru Nagar was recorded at 812 micrograms per cubic metre. Based on this measurement, the Central Pollution Control Board (CPCB) reported an AQI of 387. Meanwhile, the US-based calculation showed a reading as high as 1,469, while the UK system recorded a score of 10.
The primary reasons behind these differences are the countries’ different calculation methods, pollution categories and averaging periods.
India’s AQI Has an Upper Limit of 500
India introduced its National Air Quality Index in April 2015. It was developed by an expert committee for the Central Pollution Control Board, with technical contributions from IIT Kanpur.
The Indian AQI system divides air quality into six categories:
- 0–50: Good
- 51–100: Satisfactory
- 101–200: Moderate
- 201–300: Poor
- 301–400: Very Poor
- 401–500: Severe
One major limitation of this system is that the AQI does not increase beyond 500. When PM2.5 concentration reaches approximately 380 micrograms per cubic metre, the index can reach its maximum value of 500.
Even if pollution levels continue to rise beyond this point, the official Indian AQI may continue to display 500. Therefore, 500 should not be interpreted as the absolute maximum level of air pollution. It is simply the upper limit of India’s AQI scale.
US AQI Can Reach 2,000
The United States Environmental Protection Agency (EPA) follows a different AQI calculation system. Unlike India’s system, the US scale can continue increasing beyond 500.
This is why some mobile applications using the US calculation method display readings between 1,000 and 2,000 during extreme pollution episodes.
In 2024, the United States tightened its PM2.5 air quality standards. Under the revised standards, a PM2.5 concentration of up to 9 micrograms per cubic metre is considered good, while concentrations above 225.5 micrograms per cubic metre fall into the hazardous category.
Under the US AQI system, a reading of 500 corresponds to a PM2.5 concentration of approximately 325.4 micrograms per cubic metre.
UK’s AQI Scale Goes Only Up to 10
The United Kingdom follows the Daily Air Quality Index (DAQI), which ranges from 1 to 10.
The system divides air quality into four categories: Low, Moderate, High and Very High.
For PM2.5, a 24-hour average concentration of 71 micrograms per cubic metre or above corresponds to the maximum score of 10.
Therefore, even in the UK, the maximum AQI score does not necessarily represent the highest possible pollution concentration. Additional measurements are required to understand the actual pollution levels.
How Should Air Pollution Be Compared Correctly?
Directly comparing AQI figures from different countries can lead to misleading conclusions. Differences in calculation methods, pollution categories and averaging periods can produce significantly different readings for exactly the same air.
Therefore, checking the actual PM2.5 concentration in micrograms per cubic metre is often more useful when comparing pollution levels across countries.
According to the World Health Organization (WHO), the recommended 24-hour average guideline for PM2.5 is 15 micrograms per cubic metre.
This makes it important to look beyond the AQI number and pay attention to the actual PM2.5 concentration to understand the severity of air pollution.


